#Vertex vx 3200 programming software manual#
#Vertex vx 3200 programming software series#

A Signal is present (Squelch is open): Level High No Signal is present (Squelch is closed): Open When you connect the solder jumper on JP2002, this port changes to PULL UP (5 V) output. None/A PORT/B PORT/C PORT/D PORT/E PORT/HA PORT Pin 23: EXT SQL Open collector output. If the HA feature is assigned to these ports, a cur- rent amplifier must be connected between the Horn circuit and the port. The possible programming features (use CE49) are illustrated below. The logic output appears at these pins when the front panel's PF key is turned on.

Pin 18: E Ground for all logic levels and power supply re- turn. If the jumper setting is 'HI-speed Data' (JP2003 jumpered), this port is usable for 9600 bps DATA communications, because the filter and limiter are not engaged in the Audio line. Output level 200 mV/600 Ohms If the Jumper setting is 'Low-speed Data' (JP2004 jumpered), this port is usable in the AUDIO (300~3000 Hz) range. Output level 600 mV/10k Ohms RX Low-speed Data Output Type (jumper JP2004).

#Vertex vx 3200 programming software manual#

Ignition 13.8V Pin 16: NC A IN CCESSORY DSUB 25-Pin Operating Manual Reprint C ONNECTOR Pin 17: RX DO RX Hi-speed Data Output Type (jumper JP2003). This feature is only enabled on transceivers con- figured for Dual Deck operation. Via programming by your VERTEX STANDARD dealer.

#Vertex vx 3200 programming software series#

View and Download Vertex Standard VX-3200 Series operating manual online. Maximum current is 20 mA.Д¬urrent list of Vertex/Standard Radio programming files available for download in the members area. Maximum output current is 200 mA Pin 15: IGN The VX-5500 may automatically be switched to the STAND-BY mode when the vehicle's igni-tion key is turned on. Switched and regulated DC 5.0V output for supplying power to an accessory (jumper JP2007).

Pin 14: DC OUT Switched 13.8V output for supplying power to an accessory (jumper JP2008). If the jumper setting is 'HI-speed Data' (JP2005 jumpered), this port is usable for 9600 bps DATA communications, because the filter and limiter are not engaged in the Audio line. Input level 40 mV/600-Ohms If the Jumper setting is 'Low-speed Data' (JP2006 jumpered), this port is usable in the AUDIO (300~3000 Hz) range. Input level 800 mV/600 Ohms, Max.input 1.2V Tx Low-speed Data input Type ( Jumper JP2006). DSUB 25-P Pin 13: TXDI TX Hi-speed Data Input Type (jumper JP2005). I found this info at: It's easier to read it there.